Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
12 VTL Configuration CLI Commands
slots=12
serial=123456XYZ
dedup=enabled
backupwindow=disabled
Listing Available Library
Models
syscli --list library
This CLI command allows the CLI admin to display a list of the available library
models. Specific library model or product ID is required when adding or creating
a new partition.
An example output of three supported library models is shown below:
Listofallavailablelibrarymodels:
Totalcount=1
[library=1]
productid=DL1500
description=EMCDiskLibrary
[library=2]
productid=Scalar100
description=ADICScalar100
[library=3]
productid=Scalari2000
description=ADICScalari2000
Listing of Supported
Tap e D r i v e
syscli --list drive
This CLI command allows the CLI admin to display a list of the available virtual
tape drive models. A specific virtual tape drive model is required when adding or
creating a new partition.
An example output of two tape drive is shown below:
Listofallavailabledrivemodels:
Totalcount=2
[drive=1]
model=QUANTUMDLTS4
description=QuantumDLTS4
[drive=2]
model=QUANTUMSDLT320
description=QuantumSDLT320
To Next Page
Loading...
