Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
VTL Configuration CLI Commands 19
If the --useccl option is specified, the Command and Control LUN feature is
enabled.
Note: The CCL (Command and Control LUN) is not used in most
environments. This option is recommended for host access groups that
contain an HP-UX host. It can also be used if hosts that are not
assigned to any host access group exist in the SAN. The CCL is
accessible to hosts only through LUN 0.
Caution: If you are not sure if you should use CCL, contact Quantum
Customer Support before you enable this option.
Deleting a SAN Client
Group
syscli --del sanclientgroup --name <VTL_name> --groupname
<group_name>
This CLI command allows the CLI admin to delete a SAN client group given the
required VTL name and the group name.
Listing VTL Storage
Locations and Index
syscli --list vtlstorage --name <VTL_name> --loc source | dest [--type drive |
slot | ieslot]
This CLI command allows the CLI admin to list the source and destination
storage locations. This is useful to determine the locations to move or unload
media command. If the --type option is specified, only locations of the specified
type is listed.
Below is a sample output of this CLI with a VTL name and destination location
specified:
syscli --list vtlstorage --name VTL1 --loc dest
Output data:
ListofVTLstoragelocations:
Totalcount=4
[storagelocation=1]
locationtype=I/ESlot
index=0
driveserialnumber=N/A
barcode=N/A
writeprotect=disabled
access=N/A
used=N/A
[storagelocation=2]
locationtype=I/ESlot
To Next Page
Loading...
