EasyManuals Logo

Quantum DXi V1000 User Manual

Quantum DXi V1000
344 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
Utility CLI Commands 69
[License=5]
LicenseName=StorageCapacity
Installed=Yes
DateInstalled=2009-06-0115:32:24
LicenseDescription=LimitStorageCapacity
[License=6]
LicenseName=OST
Installed=No
DateInstalled=‐‐NotInstalled‐‐
LicenseDescription=LimitOpenStorageServerConnections
[License=7]
LicenseName=Vision
Installed=No
DateInstalled=‐‐NotInstalled‐‐
LicenseDescription=EnablesAdvancedReporting
Adding a License
syscli --add license --key <license_key>
This CLI command allows the admin user to add a license on the system. The
user needs to provide a key corresponding to the license.
Note: For DXi4510 and DXi 4520 systems, all available licenses are
pre-installed at the factory. There is no need to add licenses to these
systems.
Note: After adding a storage capacity license to DXi4601, you must reboot
the DXi to complete the storage capacity upgrade. The new storage
capacity will not be available until you reboot the DXi.
Diagnostic Logs Generating a Diagnostic Log
syscli --gen diaglog [--system] | [--array] [--quiet] [--lastgen]
This CLI command allows the admin user to generate diagnostic logs on the
system.
CLI command options:
--system: generates the system diagnostic log. This is the default if no
diagnostic type is specified.
--array: generates the raid array diagnostic log

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Quantum DXi V1000 and is the answer not in the manual?

Quantum DXi V1000 Specifications

General IconGeneral
BrandQuantum
ModelDXi V1000
CategoryStorage
LanguageEnglish

Related product manuals