Quantum DXi V1000

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
68 Utility CLI Commands
Node Management syscli --nodemanage --reboot | --shutdown | --resetdiag [--node {1 | 2|
all}] [--sure]
This CLI command allows the admin user to reboot, shutdown or reset the
diagnostic state on a node. If the --sure option is specified, no confirmation
prompt is displayed. Note that --node 2 is an invalid option in release 2.x.
License Management The following license management commands are available:
• Displaying Licenses
• Adding a License
Displaying Licenses
syscli --list license
This CLI command allows the user to list the available licenses on the system. An
example output of available licenses is shown below:
ListofLicenses:
Totalcount=7
[License=1]
LicenseName=NAS
Installed=No
DateInstalled=‐‐NotInstalled‐‐
LicenseDescription=ExposeNASinterfacetohost
[License=2]
LicenseName=BackupApplicationSpecific
Installed=No
DateInstalled=‐‐NotInstalled‐‐
LicenseDescription=EnablesBackupApplicationSpecific
[License=3]
LicenseName=De‐Duplication
Installed=Yes
DateInstalled=2009-06-0115:32:42
LicenseDescription=EnablesDe‐Deduplication
[License=4]
LicenseName=Replication
Installed=Yes
DateInstalled=2009-06-0308:59:17
LicenseDescription=EnablesReplication