Quantum DXi V1000

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
Network CLI Commands 81
Deleting a Route From
the System of Network
Device
syscli --del route [--devname <DEVNAME>] --network <IPADDR> [--sure]
This CLI allows the admin user to delete the route for the system (and optionally
for a network device).
Note: The system does not automatically reboot; therefore, after making any
modification to your network configuration, you must manually reboot
the system. You can reboot the system using the sysclil --nodemanage
--reboot command.
CLI Command Options:
• --del: Deletes route for the system or network device.
• --devname: Device name. The general format is
<label><devno>[:<vifno>] where
• label: Device label, which is an alphabetic string (e.g. bond, eth, ...)
• devno: Device number, which can range from 0 to possibly 99,
depending on actual systems.
• vifno: Virtual interface number, which is optional and can range from 1
to possibly 99, depending on actual systems.
• --network: IP address in decimal dotted notation (e.g. 10.20.30.0).
• --sure: if specified, the command will execute without asking for
confirmation.
Listing Static Routes syscli --list route
This CLI allows the user to display the static routes for the system.
--list: Lists the static routes.
Deprecated Network
CLI Commands
The following network CLI commands are deprecated:
• Enabling Jumbo Frames
• Disabling Jumbo Frames
• Getting Jumbo Frame Status
• Setting Up a Segmented Network
• Setting Up an Unsegmented Network
• Querying the Network
• Undoing a Network Configuration
Enabling Jumbo Frames
syscli --enable jumbo
DEPRECATED. Use the syscli --add netcfg command to set jumbo frame status
instead.