EN.
45
NOTE: Power consumption needs to increase or decrease by at least 1 Watt to be reported,
REGARDLESS of the percentage set in this parameter.
Parameter no. 42 – Power reporting in Watts by time interval for Q1 or Q2
The set value refers to the time interval with which the power consumption in Watts is reported
(0 – 32767 seconds). If 0 is entered, energy consumption reports will not be sent to the gateway
(hub).
Values (size is 2-byte dec):
• default value 0
• 0 - Power consumption reporting disabled
• 1 – 32767 = 1 - 32767 seconds. Power consumption reporting enabled. Report is sent
according to time interval (value) set here.
To Next Page
Loading...