Why does my Quer Micropower 400 beep continuously when the power is on?
The alarm buzzer may beep continuously due to an overload on the UPS. To resolve this, verify that the load connected to the UPS does not exceed the UPS capability specified in the specifications.
What to do if my Quer UPS backup time is short after a power failure?
A short backup time during a power failure can occur due to several reasons: * The UPS might be overloaded. Try removing some non-critical devices to reduce the load. * The battery voltage might be too low. Charge the battery for at least 8 hours. * The battery may be defective due to high temperature or improper operation. If this is the case, replace the battery with the same type.
How to fix no LED display on my Quer Micropower 400 front panel?
If there is no LED display on the front panel of your Quer UPS, the issue may be due to: 1. A weak battery: Charge the battery for up to 8 hours. 2. A defective battery: Replace the battery with the same type. 3. The power switch not being pressed: Press the power switch again.
What to do if the yellow LED is flashing on my Quer Micropower 400?
If the yellow LED is flashing while the mains are normal, it may indicate that the power cord is loose. Reconnect the power cord properly to resolve this issue.
To Next Page
General