11
Owner’s manual
EN
AC input
Output
receptacles
RS232
communication
1. Inspection
Remove the UPS from its packaging and inspect it for damage that may have occurred
during shipping. If any damage is discovered, repack the unit and return it to the place
of purchase.
2. Charging
This unit is shipped from the factory with its internal battery fully charged, however, some
charge may be lost during shipping and the battery should be recharged prior to use.
Turn on the UPS, Plug the unit into an appropriate power supply and allow the UPS to
charge fully by leaving it plugged in for at least 6 hours with no load (no electrical devices
such as computers, monitors, etc.) connected.
6 hours
To Next Page
Loading...