Troubleshooting – Continued
Not Heating
Verify the machine is plugged into the outlet and the outlet has power. Also check the power
cord and make sure it it properly installed into the back of the machine. Verify the power
switch is in the on position.
Check the resettable hi-limit switch on the boiler to see if it is tripped. Unplug the machine
from the outlet and remove the outer body panels. Locate the resettable hi-limit switch on
top of the boiler shown in the picture to the upper right. Press the small center button down
firmly to reset. Re-install the outer body panels and then plug the machine back in and turn
the power switch to the “on” position. Wait 15 minutes for the machine to heat up.
Make sure the water reservoir is filled with water and is fully seated as far down into the
machine as it can go.
To Next Page
Loading...
