Need help?Do you have a question about the Quick MILL Vetrano 2B Evo and is the answer not in the manual?
General| Type | Espresso Machine |
|---|---|
| Boiler Type | Dual Boiler |
| Boiler Material | Stainless Steel |
| Pump Type | Vibratory Pump |
| Pump Pressure | 15 Bar |
| PID | Yes |
| OPV Valve | Yes |
| Water Source | Reservoir |
| Voltage | 120V |
Access point for the water reservoir.
The top surface designed for warming cups.
Control knob for operating the steam wand.
Digital interface for temperature management.
Control knob for dispensing hot water.
The nozzle attached to the steam wand.
The main group head assembly for brewing espresso.
Dispensing spout for hot water.
Removable tray to catch drips and spills.
Handle that holds the coffee grounds for brewing.
Activates the brewing cycle via mechanical linkage.
Monitors the pressure within the steam boiler.
Monitors the pressure at the brew group.
Controls for activating the coffee and steam boilers.
Lights indicating the operational status of boilers.
Lights indicating the heating element status.
The outlet port for draining the drip tray.
Selects between internal reservoir or direct plumbing.
Status indicator lights for machine functions.
Valve control for managing water source input.
Connection fitting for a plumbed water supply.
Attach water line to machine and water source using provided fittings.
Inspect connections for leaks and verify pump fills without excessive delay.
Prepare machine, locate feet, and set water source switch.
Assess and condition water supply; avoid distilled or RO water.
Fill reservoir or ensure direct plumbing switches are set.
Ensure knobs are closed and brew lever is down before plugging in.
Connect the appropriate power cord, using converter if needed.
Verify power switches are off and indicator lights are unlit.
Fill reservoir to max line and reseat until alarm stops.
Plug in, turn on boilers, and check for green indicator lights.
Install portafilter and allow machine to heat for optimal temperature.
Interpreting steam and brew pressure readings.
How steam pressure behaves and responds to usage.
Achieving accurate brew pressure readings.
Functionality of the low water alarm and its impact.
Guidelines for using the hot water wand and capacity limits.
Prepare portafilter with backflush disk for accurate reading.
Access the rotary pump's adjustment screw.
Adjust brew lever and pump screw to set desired pressure.
Verify final pressure and note potential grinder adjustments.
Feature for placing the steam boiler on standby after inactivity.
Configure the 60-minute standby timer for the steam boiler.
Configure automatic standby mode activation and deactivation.
Adjust the target temperature for the coffee boiler.
Adjust the target temperature for the steam boiler.
Detailed diagram and guide for disassembling the E61 group.
Instructions on performing regular backflushing for machine care.
Information on maintaining the E61 group head components.
To Next Page