Quick AL3 Series - Supply and Equipment; Standard Supply and Included Materials; Required Installation Tools; Recommended Optional Accessories

EN
AL3 Series
AL3 Series
QUICK AL3Series INSTALLATION AND USER’S MANUAL - REV000A
6
2.0 - Standard supply and material included in the package
• Windlass (top+gearmotor)
• Contactor box
• Base gasket
• Lever
• Screws for assembly
• Manual anchor weighing (no drum version)
• Installation and user’s manual, Warranty
• Drilling template
2.1 - Tools required for installation
• Drill with bit: Ø 9 mm (23/64”) e Ø 11 mm (7/16”)
• Hole saw 75 mm (2”7/8)
• Hex wrench: 13 mm
2.2 - Recommended Quick
®
accessories not included
• Controls for control board (Serie WCS)
• Waterproof push-button panel (HRC 1002)
• Foot switch (900)
• Hydraulic-magnetic circuit breaker (WCB)
•Anchor chain counter (CHC 1203, CHC 1103, QNC CHC)
•Control system via RRC radio (R02 - P02 - H02)
2 - Supply and equipment
BEFORE USING THE PRODUCT, PLEASE READ THIS USER’S MANUAL CAREFULLY. IF IN DOUBT, PLEASE CONSULT YOUR QUICK® DEALER.
3.0 - Important notes
This manual features Warning and/or Caution symbols that are important for safety.
Please follow the instructions provided.
Warning symbol indicating
dangerous situations.
Caution symbol to prevent direct or
indirect damage to the product.
This manual provides boat manufacturers and nautical equipment installers with instructions on how to assemble the specied
Quick® product and operate it correctly.
3 - Introduction