21
GB
GP2 SERIES GENIUS 500/1200 - REV001A
21
MAINTENANCE
WARNING:
make sure the electrical power to the motor
is switched off when working manually on the windlass.
Carefully remove the chain from the gypsy.
Quick
®
windlasses are manufactured with materials resistant
to marine environments. In any case, any salt deposits on the
outside must be removed periodically to avoid corrosion and
damage to the equipment. The parts where salt may have built
up should be washed thoroughly with fresh water.
Once a year, the drum and the gypsy are to be taken apart as
follows:
MOD. 500
Use the handle (1) to remove the gypsy cover (2); remove the
top clutch cone (3); loosen the fixing screws (5) of the chain
stripper (7) and remove it and pull off the gypsy (4).
Clean all the parts removed to avoid corrosion, and grease the
shaft thread (19) and the gypsy (4) where the clutch cones (3)
rest (use grease suitable for marine environment) .
Remove any oxide deposits from the terminals of the electric
motor and the reversing contactor unit; grease them.
POS. DESCRIPTION
11 White plastic 150 windlass cover
12 Screw for pressure lever
13 Spring for pressure lever
14 Pressure lever
15 Sensor
16 Gasket watertight
17 Bearing
18 Output gear
19 Shaft series
20 Plug
21 Circlip
22 Bearing
23 Gear
24 Gear
25 Plug
26 White plastic 150 windlass base
27 Screw
28 Screw
29 Motor
30 Screw
31 Mooring rope puller pin
32 Plug
33 Washer
34 Roller bearing cage
35 Gear wheel
36 Gear motor shaft
37 Gasket/jig
38 Studs
39 Washer
40 Spring washer
41 Nut
42 Hexagonal cheese-headed screw
43 Spacer
44 O-ring
To Next Page
Loading...
Need help?
General
