MAINTENANCE
The battery charger does not need any maintenance. To ensure optimum performance from the equip-
ment, once a year check the cables and the electrical connections.
CONTROL PANEL
The control panel is made-up of three LEDS:
POWER LED, FLOAT LED and CHARGE LED (BULK, ABSORPTION, see fig.4)
The information supplied by the LEDS are listed below:
OPERATING - MAINTENANCE
GB
18
FLOAT LED
LED COLOR
FLOAT Phase
- FLOAT charge
Short circuit or overload in output.
Check output cables, the group of batteries and the points of use connected to the battery charger.
LED STATUS DESCRIPTION
Green
Green
Fixed
Flashing
CHARGE LED (BULK, ABSORPTION)
LED COLOR
ABSORPTION phase or BULK phase
Short circuit or overload in output.
Check output cables, the group of batteries and the points of use connected to the battery charger.
LED STATUS DESCRIPTION
Yellow
Yellow
Fixed
Flashing
POWER LED
LED COLOR
No mains power - Overheating - Short circuit - Overload.
In case of overheating check if the installation of the battery charge is correct.
Switch off and allow the equipment to cool down for at least 10 minutes.
Power ON
DESCRIPTION
Off
Green
To Next Page
Loading...
Need help?
General
