Quicksilver Activ 605 Open - Fire Prevention

16
Quicksilver 605OP — System & Component Overview and Operaon
If water does not come out of the discharge hose:
1. Remove the motor module to see if the impeller rotates with the power on.
2. Remove any debris that may have accumulated in the nozzle secon or strainer base.
3. Check hose and connecon on hull side for debris and proper connecons.
4. If water ever entered the forward part of the bilge, the water can sll be evacuated by the
bilge pump.
If water ever enters the forward part of the bilge, there is an inspecon plate located in the console,
when removed, allows access to a drain plug. Simply remove the drain plug in the PVC pipe to allow
the water to drain a. Once all of the water has drained, re-install the drain plug.
Inspecon plate
Drain plug
Forward Drain Plug
Check the funcon of all bilge pumps at regular intervals.
Clear pump inlet from debris.
The bilge pumping system is not designed for damage
control.
Do not operate vessel unless the forward drain plug is
properly installed and secured. If the plug is not installed
and secured in place, fuel vapors and / or Carbon Monoxide
can migrate forward into areas that do not have proper
venlaon. This could lead to serious injury or death.
4. Fire Prevenon
Fire is a serious boang hazard. Boats will burn quickly. Do not remain onboard and ght a re for
more than a few moments. If the re is out of control and cannot be put out with the re suppression
equipment onboard, abandon ship immediately.
The boat, when in service shall be equipped with the following portable re exnguishers:
1. Fire Rang 13A 89B C
The boat owner/operator shall:
1. Have the re ghng equipment checked at the intervals indicated on the equipment.
2. Replace portable re exnguisher, if expired or discharged, by devices of idencal re ghng
capacity.