Quicksilver Activ 675 Sundeck User Manual

19
Quicksilver 675SD — System & Component Overview and Operaon
Carbon Monoxide Monitor
The CO monitor is an electronic instrument that detects carbon monoxide. The detector is very
sensive and will nofy you before dangerous amounts of CO can accumulate which will allow you to
take measures to dissipate the gas from the aected areas. When there is a buildup of CO in the
cabin, the monitor will alert the occupants by ashing a DANGER light and sounding an alarm. The CO
monitor is powered through a breaker on the baery panel in the cockpit.
It is important that you read and understand the CO monitor informaon and operang instrucons.
It is extremely important that you become familiar with the CO monitor and its funcons.
Tesng the CO Monitor
Test the monitor on your boat at manufacturers required intervals by pushing the TEST buon on the
front of the unit. If the unit is operang correctly both audible and visual warning indicators will be
acvated.
End of Life Signal
Your CO detector is equipped with an End Of Life (EOL) signal indicang the sensor used in the unit
has reached the end of its service life and must be replaced. The detector contains an electro-
chemical sensor that will last approximately 7 years. Refer to your unit’s operaon manual for EOL
signal indicaon and further informaon and instrucons.
The EOL signal can be deacvated so that it does not alarm. DEACTIVATING THE CO ALARM IS
PERMANENT. REACTIVATING IS NOT POSSIBLE. DO NOT DEACTIVATE UNLESS YOU HAVE A
REPLACEMENT ALARM AVAILABLE TO INSTALL!
REFER TO OWNER’S MANUAL PACKAGE FOR INSTRUCTIONS AND WARRANTY INFORMATION.
Accumulaon of Carbon Monoxide Examples
Wind blowing exhaust towards boat occupants
Operang at slow speed or dead in the water
Operang with “bow high” atude Good air ow — open all hatches, portlights or
canvas openings to let fresh air circulate

Quicksilver Activ 675 Sundeck Specifications

General

Brand	Quicksilver
Model	Activ 675 Sundeck
Category	Boat
Language	English