Quicksilver Activ 675 Sundeck User Manual

Quicksilver 675SD — Electrical Systems
28
1. DC Electrical System
The DC electrical system is powered by a single baery, and is kept charged by the engine driven
alternator. The baery voltage is indicated by the voltmeter screen located on the SmartCra®
tachometer, or on the oponal GPS with Vessel Link.
2. Baery
Quicksilver® recommends AGM type starng or a deep cycle baery for you boat. The baery must
meet the minimum capacity required by the engine manufacturer. Refer to your engine owner’s
manual for exact baery requirements.
To remove the baery cables:
1. Turn o all items drawing power from the baery.
2. Turn the baery switch to the OFF posion.
3. Remove the negave cable rst, then the posive cable.
To replace the cables, install the posive cable rst, then the negave cable.
3. Baery Box
The baery box, located in the a bilge, houses the baery. This box can be accessed via the hatch
located in the port a lounge storage tub. The baery can be installed or removed by loosening the
strap and removing the lid on the baery box. It should always be installed and secured within the
baery box installed on your boat. This will ensure that the baery will not move around while the
boat is underway.
4. Baery Switch
Your vessel is equipped with a baery switch to control the delivery of DC power from the baery.
The baery switch panel is located in the a lounge storage tub. When you turn the baery switch to
the ON posion, power is provided from the baery to the enre boat. To turn on power, rotate the
switch clockwise 90 degrees to the ON posion.
Never use an open ame in the baery storage area. Avoid
striking sparks in the baery area.
Always disconnect the baery before doing any work on the
electrical system. Never turn o the baery switches or
disconnect the baery cables while the engines are running.
The bilge pumps sll draws power from the baery, even if
the switch is set to OFF. This is especially important for the
bilge pump, so that it can operate anyme excess uid
accumulates in the bilge, which can occur when the boat is
docked and unaended.
Never work on the electrical system while the system is
energized. Never leave the cra unaended with the
electrical system energized.
Baery Switch Operaon
OFF Posion
ON Posion

Quicksilver Activ 675 Sundeck Specifications

General

Brand	Quicksilver
Model	Activ 675 Sundeck
Category	Boat
Language	English