Quicksilver 675SD — System & Component Overview and Operaon
20
6. Bow Anchor Windlass
The anchor windlass located at the bow of the boat assists with the anchoring of your boat by
automacally raising and lowering the anchor. The windlass is operated from the helm.
Operaon
To operate the windlass, the windlass breaker, located next to the baery switch panel, must be
turned ON. Operaon of the windlass at the helm is controlled by a momentary switch used to raise
and lower the anchor. Pushing down on the switch will lower the anchor, while pushing up on the
switch raises the anchor.
Fumes for the engine(s), generator, LPG stoves, and other
equipment that burns fuel contain Carbon Monoxide.
Carbon Monoxide can kill you. Open all doors, hatches,
curtains, and windows to allow fresh air to circulate.
Never ignore an alarm.
To reduce the risk of Carbon Monoxide poisoning, test the
monitor operaon when not in use for 10 days or more.
Anchor Windlass
Bow windlass
Bow windlass breaker
Bow windlass switch
Before operang the windlass, make sure that the safety
lanyard is removed from the anchor
Manual operaon
In the event that there is a loss of power, the windlass can sll be used to raise or lower the anchor
manually. If there is a loss of power, check the windlass breaker to see if it needs to be reset. If you
Carbon Monoxide Monitor
Power indicator light
Alarm indicator light
Horn
Test buon
To Next Page
Loading...
Need help?
General
