Cut all the Entry Points for all the Compression
Struts and the Diagonal Strut.
Whatever Method you choose be
carefull to only cut the intended surface.
The Preferred method is to use a Hot Knife
A dedicated tool that is used for Wood Carving.
A modified Soldering Iron is the most common
tool. Simply shape the soldering tip into a
Blade Shape.
SEE COMPRESSION STRUT CUT OUT TEMPLATE SECTION 12
WING COVER ATTACHMENT (CONT’D)
One method of Cutting the holes in the
fabric is to use a Razor Knife and then
heat seal the fabric edges with a Soldering
Iron.
USE SOLDERING IRON
TO HEAT SEAL THE
CUT EDGE
CUT OUT HOLE IN
WING COVER
To Next Page
Loading...
Need help?
General
