DECLARATION OF COMPLIANCE
(by the installer)
The undersigned:
Address:
in charge of the set-up, declares that the product:
Gate type:
Location:
are in compliance with the essential safety requirements of the regulations:
! Regulation 89/392CE on Machinery and its subsequent amendments;
! EMC Regulation 89/336/CE (Legislative Decree 615/96);
! BT Regulation 73/23/CE e 93/68/CE (Legislative Decree 626/96);
! CE Machinery Directive 98/37 and directive 93/68/CE-72/23/CE-92/31/CE;
and also declares that the related and/or specific national technical regulations have been
followed:
! EN 12453/EN 12445 on Industrial, Commercial and Residential Gates and Doors – Safe
Use of Motorized Doors – Requirements and Classification – Test Methods;
! EN 12604/ EN 12605 on Industrial, Commercial and Residential Gates and Doors –
Mechanical Aspects – Requirements and Classification – Test Methods;
! CEI 64/8 Electrical Systems Using Nominal Tension Not Higher Than 1000V a.c. and 1500
V d.c.;
! EN 13241-1 (Industrial, commercial and garage doors and gates), conformity evaluation
(6.3).
Notes:
Place and date: ………………………………………
To Next Page
Loading...
Need help?
General
