Page 5For technical questions, please call 1-888-866-5797.Item 58950
Maintenance and Servicing
Procedures not specifically explained in this manual
must be performed only by a qualified technician.
TO PREVENT INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs,
have the problem corrected before further use.
1. BEFORE EACH USE, inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2. AFTER USE:
• pull down the Adjusting Ring, set
to the lowest torque setting, then
release the Adjusting Ring.
• wipe Torque Screwdriver with a clean
cloth. Do not use liquid on the cloth or
immerse Torque Screwdriver in liquid.
3. EVERY 6 MONTHS, have the
Torque Screwdriver calibrated and
serviced by a qualified technician.
To Next Page
Loading...