Disconnecting tank
• In case of service.
• The Q-shaped button on top of the tank is the on/off switch.
1 Switching off
Press the on/off switch at the top of
the tank to switch it off. Leave the
socket switched on and do not unplug
the tank from the socket yet.
2 Draining
Open the boiling-water handle of the
tap and leave the water running until
it is cold. Then close the handle again.
3 Isolating
Close the main shut-off valve or the
stop valve on the inlet combination
valve (small grey knob). Check that the
Quooker is depressurized by opening
the boiling-water handle of the tap
again. If it is depressurized, no water
should flow out of it.
4 Disconnecting
Unplug the tank from the socket and
the LED cable from the back of the
tank cover. Disconnect the tap and
inlet hoses and remove the tank. Drain
the tank into the sink via the hoses.
F
1 2
3 4
To Next Page
Loading...
