Do you have a question about the R82 Stingray and is the answer not in the manual?
Brand | R82 |
---|---|
Model | Stingray |
Category | Wheelchair |
Language | English |
Mount holders (A) at each seat side using finger screws, removing protection cap.
Mount fitting (C) to plate (D), aligning markers for Stingray Sz. 1 or Sz. 2.
Assemble tray rods (E, F) and mount into fitting (C) using finger screw and bolt (G).
Mount the assembled tray into the holders (A) on each side of the seat.
Adjust tray depth by loosening bolt (G) or finger screw (H) under the tray.
Adjust the angle of the tray by loosening screws (I) on both sides.
Adjust the tray's height by moving screw (J) up or down.