RAB Lighting FFLED39 - User Manual

FFLED39 INSTALLATION INSTRUCTIONS
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. For xtures weighing more than 10lbs: Do not mount to an outlet cover unless a
separate splice box is used. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining xture. No user serviceable
parts inside.
Thank you for buying RAB lighting xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000, or email: marketing@rabweb.com
LOCATION
1. Seal arm thread using teon tape or silicone sealant.
2. Secure the LED Flood to a 1/2” NPS hole in a
junction box or landscape post.
3. Plug all unused holes and seal threads with silicone.
4. The swivel arm on the LED Flood allows 180º of
vertical aiming adjustment depending on mounting
location.
GUARD OR SHIELD INSTALLATION
Wire Guard and Poly Shield mount with (4) #8-32
Stainless Steel Screws. Screws are provided with
accessory. See gure 1 for Guard. See gure 2
for Shield
1. Line up guard with pre-existing, pre-drilled holes in
frame as shown, tighten screws.
GUARD & SHIELD INSTALLATION
The Wire Guard and Poly Shield can be mounted on the
same xture with (4) #8-32 screws as shown below.
Stainless
Steel
Screws
Stainless
Steel
Screws
Figure 1
Figure 2
WIRING
Universal voltage drivers permit operation at 120V to
277VAC, 50 or 60 Hz except xtures factory ordered
with a 120V photocell (/PC)
1. Connect the BLACK xture lead to the
(+) LINE supply lead.
2. Connect the WHITE xture lead to the
(-) COMMON supply lead.
3. Connect the bare copper Ground wire from xture
to supply ground.

Summary

IMPORTANT INFORMATION & SAFETY

Read and Retain Instructions

Read carefully before installing and retain these instructions for future reference.

Wiring and Grounding Compliance

Wire in accordance with NEC and local codes. Proper grounding is required for safety.

Installation by Qualified Person

Power Off Before Servicing

Make certain power is OFF before installing or maintaining. No user serviceable parts inside.

LOCATION GUIDELINES

GUARD AND SHIELD INSTALLATION

WIRING INSTRUCTIONS

Connect Line Wire

Connect the BLACK fixture lead to the (+) LINE supply lead.

Connect Common Wire

Connect the WHITE fixture lead to the (-) COMMON supply lead.

Connect Ground Wire

Connect the bare copper Ground wire from fixture to supply ground.

TROUBLESHOOTING GUIDE

Verify Line Voltage

Confirm Grounding

RAB Lighting FFLED39 Specifications

General

Brand	RAB Lighting
Model	FFLED39
Category	Flood Light
Language	English