RAB Lighting Stealth STL200 - Safety and Mounting; Important Cautions; Mounting Plate and Installation

1
CAUTIONS:
TURN OFF ALL POWER AT CIRCUIT BREAKER/FUSE PANEL.
• Read entire Installation Manual before proceeding.
• All wiring should comply with local electrical codes and
requires a qualied electrician
• The total lighting load connected to a STEALTH must not exceed 8
amps (1000 watts incandescent). To switch more wattage an electrician
can install a relay.
• Line Carrier Remote Control Systems such as X-10, Levitron or Radio
Shack are incompatible with sensors and cause false activations.
• Do not install sensors on a circuit that feeds motor loads like kitchen
appliances, HVAC equiptment, washer/dryer, or garagedoor openers.
• Sensor must be below and as far as possible away from lights.
• Sensor functions best when the direction of expected
movement is across its detection pattern, not towards the sensor.
• Mount 6-12 feet high for optimum range and detection.
Mounting Plate:
STL200 Floodlight kits come with the RAB CU4 EZ plate, allowing for
mounting on round, rectangular or octogonal surface or recessed box.
Mounting
Bar Screws
Universal
Mounting
Bar
Hook
Gasket
Insert close-up plugs
in unused holes
Finishing
Cap
Center
Screw
O-Ring
Gasket
CU4 EZ Plate