Safety Information
WE’RE HERE TO HELP:
1 (844) LIGHTCLOUD
1 (844) 544-4825
support@lightcloud.com
• To avoid risk of fire and electrical shock, products shall be installed
in accordance with electrical code and regulations.
• Cutoff the power at the circuit breaker or fuse before installation.
• If you’re not clear about any content of the instructions, please
consult a licensed electrician.
• To avoid the risk of overheating and possible damage to the
equipment, do not use the product to control a receptacle,
motor-operated appliance or a transformer-supplied appliance.
• This product applies to compatible, dimmable incandescent,
magnetic low-voltage halogen, electronic low-voltage halogen,
CFL and LED products.
• When connecting multiple products with a single dimmer, do not
mix product types. All products shall be either dimmable LED, CFL
or incandescent products. Using the same type of products will
enhance dimmer performance.
• Terminal screw torque: 0.55N.m.
• Switch to the leading edge control mode when an inductive load
(i.e., incandescent or magnetic low-voltage halogen) is used.
Switch to trailing edge control mode when a capacitive load
(i.e., electronic low-voltage halogen, CFL or LEDis used.
• The best installation height of XDIM/LCBS: 4ft.
To Next Page
Loading...