Remote Supervisory Control Output
C-4 Verbatim Owner's Manual
u To turn output # N on for a specific number of seconds, use code
9 5 N 2 XXXXX ENTER
where XXXXX is the desired number of seconds, from 1 to 99999.
u To turn output # N off for a specific number of seconds, use code
9 5 N 3 XXXXX ENTER
where XXXXX is the desired number of seconds, from 1 to 99999.
u To establish a default pulse time duration in seconds for a given output N
(2 digits), use code
9 5 N 9 XXXXX ENTER
where XXXXX is 1 to 99999 seconds.
u Alternatively, to establish a default pulse time duration in minutes, for
individual output N (2 digits), use code
9 5 N 8 XXXX ENTER
where XXXX is 1 to 1666 minutes.
Then you may use code 9 5 N 2 (or 3) without need to enter the digits.
The unit will use the pre-stored value for that output’s pulse length.
u To hear a report of the on/off status of ALL outputs in one operation, use
program code
9 5 0 0 ENTER
u To turn ALL outputs OFF in one operation, use code
9 5 0 0 0 ENTER
u To turn ALL outputs ON in one operation, use code
9 5 0 0 1 ENTER
u To establish a default pulse time duration for ALL outputs in one
operation, use code
9 5 0 0 8 XXXX (XXXX = 1 to 1666 minutes)
or
9 5 0 0 9 XXXXX (XXXXX = 1 to 99999 seconds)
To Next Page
Loading...
