Raco Verbatim - Page 49

Advanced Programming
Verbatim Owner's Manual 6-9
Programming Code (Page 7 of 8)
Code Description & Comments Default Range/Values Notes Section
See p. 6-2
Miscellaneous Programming Items . . . Continued from p. 6-8
932 Invokes one-time 15-second OFF 6.2.18
listening period
933 0/1 Sets local microphone OFF 0/1 6.2.18
ON or OFF 0 = OFF
1 = ON
934 0/1 Sets speaker ON or OFF ON 0/1 6 6.2.18
1 = ON
0 = OFF
Clear Out Operations
935 0 Clears out phone numbers; 6.2.19
sets all delays to defaults
935 1 Clears out phone numbers only 6.2.19
935 2 Clears out all alarm call grouping linkage 6.2.19
935 3 Sets the following delays to 921 sets power 6.2.19
their factory default values: failure alarm ON
902, 903, 904, 920, 921, 926, 928
935 4 Clears all user recorded messages 6.2.19
935 5 Clears all programming except messages does not clear 6.2.19
913, 930, 941, 942
935 6 Clears all totalizers to 0 (not to preset) reading 6.2.19
935 7 Clears real-time clock chip (reinitialize) 2.3,
6.2.19, 8.9
935 9 Total clearout: does not clear 3.1,
Erases all programming & messages 941, 942 6.2.19
Diagnostic Readouts
940 Reads all 4 diagnostic counts (add 0 to clear all 4) 6.2.20
940 1 Reads call in count (add 0 to clear) 6.2.20
940 2 Reads dial out count (add 0 to clear) 6.2.20
940 3 Reads acknowledged alarm count (add 0 to clear) 6.2.20
940 4 Reads power failure alarm count (add 0 to clear) 6.2.20
927 0/1 Sets intercall delay parameter 0 0/1 ** Firmware
Values: version 2.01+ only**
0 = Normal operation of intercall delay.
1 = If new Unacknowledged alarms occur during the
intercall delay period, the unit will begin a new
dialout immediately. The unit will dial the next
phone number in the dialing sequence. It will not
start over at the top of the list.
928 N Extends length of inserted 1 sec 1-10 sec 5.7, 6.2.7
dialing delays to N sec
930 0/1 Sets arm or disarm unit armed 0/1 6.2.18
for alarm callouts 0 = disarms
1 = arms unit