Advanced Programming
6-10
Verbatim Owner's Manual
Local Alarm/Line Seizure
960 0 Read local alarm relay/line seizure H.8
960 00/01 Set local alarm relay/line seizure 00 00/01 H.8
00 = local alarm relay
01 = line seizure
6.2 Programming Operations
The following descriptions show the relevant program codes in parenthesis, and
are organized according to their appearance in the preceding Program Codes
table located in Section 6.1, “Program Codes.”
Refer also to Section 5, “Using Your Verbatim Autodialer,” for a description of
over-the-phone programming.
6.2.1 Channel Status Reading
Code Function Description
0 ZZ Read Status of Plays the message that corresponds to the present
Channel ZZ input condition of Channel ZZ.
0 ZZ 0 Read Open/Closed Says “Channel ZZ is closed” if channel ZZ input is
Circuit Status Directly presently Closed Circuit, or “Channel ZZ is open” if
the input is Open Circuit. Useful in troubleshooting,
especially at setup time.
Note:
If a channel is disabled, its status will never be mentioned.
Programming Code (Page 8 of 8)
Code Description & Comments Default Range/Values Notes Section
See p. 6-2
6.2.2 Message Recording and Reviewing
Be sure to refer to Section 4, “Record Voice Messages,” for important details on
message recording, including codes 911, 912, 913, and 914.
Code Function Description
100 Record Station Message
1 ZZ Record Channel ZZ Used for Open Circuit message for channels pro-
Alarm Message grammed for NO ALARM (status only), or for Run
Time Meter operation. Also used for a preamble
message for channels programmed for Totalizer
or Analog function.
To Next Page
Loading...
