85
EN
25.6 Menu 9.6 - Configuring the blockage detection
(not available for the Troll Comfort 3D)
The Troll Comfort is able to monitor the torque of motors equipped with
a mechanical end point setting. This enables the controller to switch off
the motor in the event of overloading or blockage. As a result, the roller
shutter is protected from damage.
i
Blockage detection can only be used in combination
with a tubular motor with mechanical end point setting.
1. Open menu 9.6.
2. Activate/deactivate the blockage
detection and confirm.
On = blockage detection on *
Off = blockage detection off **
* Continue with point 3.
** After deactivation and confirmation, the
display jumps back to the menu.
3. Select and confirm the suitable motor type.
A list of the motor types is provided
on the following page.
Please also read the instruction manual for the
tubular motor being used.
To Next Page
Loading...
Need help?
General
