Radial Engineering BT-PRO V2 - Specifications

Radial Engineering Ltd.
BT-Pro™ Bluetooth DI
True to the Music
®
8
* Subject to change without notice.
SPECIFICATIONS*
* Subject to change without notice.
Audio Circuit Type: ...........................................Bluetooth A2DP receiver with audio line drive
Bluetooth Compliance: ......................................Bluetooth 5.0
Data Compression: ........................................... SBC Codec
Compatibility: .....................................................All Bluetooth A2DP compliant devices
Device Range: ...................................................≥30m (100’) Typical: line-of-sight
Frequency Response: .......................................20Hz to 20KHz
Dynamic Range: ...............................................90dB
Signal to Noise: .................................................90dB
Maximum Gain: ................................................+4dBu (source le dependent)
Total Harmonic Distortion: ................................0.05%
Output Impedance: ...........................................150Ω
Features
Audio Output: ....................................................2x Balanced XLR-M
Headphone Output: ..........................................3.5mm TRS
Level Control: ....................................................Variable, works on headphone and XLR
Mono Switch: ....................................................Sums Left and Right Channels
Ground Lift: ....................................................... Lifts pin 1 on both XLR Outputs
General
Construction: ....................................................14 gauge steel outer shell, molded nylon insert
Finish: ................................................................Durable powder coat
Size: (W x H x D) ...............................................3.3” X 5” X 2” (84 x 127 x 51mm)
Weight: .............................................................1.1lbs (500g)
Power: ...............................................................USB-C connector (Power Only) or 48V Phantom
Warranty: ..........................................................Radial 3-year, transferable
FCC IDENTIFIER: 2AJYKTS-BT35A01
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation
The BT-Pro contains Digital devices that are susceptible to Electrostatic
Discharge (ESD), precautions should be observed for optimal system
performance.