What causes general PCB malfunction in Radiant Boiler?
General PCB malfunction in a Radiant Boiler is caused by a microprocessor malfunction where it detects a wrong signal. The PCB resets the error automatically.
What happens if the electric power supply is outside the operation range for a Radiant RBS 24 Boiler?
If the electric power supply to your Radiant Boiler is outside the operation range (?160 / ?285 volts), check the power supply network. The error disappears automatically when the power supply is back within the required range.
General| Efficiency | 95% AFUE |
|---|---|
| Modulation Ratio | 5:1 |
| Heat Exchanger Material | Stainless Steel |
| Fuel Type | Natural Gas |
| Input BTU | 24, 000 BTU/h |
To Next Page