26
When the Weatheradio’s alert function is turned on
and it receives an NWS alert broadcast, the Weath-
eradio sends a 7.5VDC signal to the connected mod-
ule interface, and an alert sounds on both the
Weatheradio and the connected system.
To remove the wires you connected to your Weath-
eradio’s
ALARM
OUT
terminals, gently pull out the
wires while using a pointed object such as a straight-
ened paper clip to press the orange tabs under the
wires.
PROGRAMMING THE
WEATHERADIO
Note:
Some of the Weatheradio’s keys (such as
0
–
9
)
are located under the cover on top of the Weathera-
dio. Slide off the cover to access the keys.
The first time you use your Weatheradio, it is auto-
matically set to use the NOAA weather broadcast fre-
quency 162.400 MHz (Channel 1) and receive all
SAME alert signals broadcast within a 50-mile radius
of where you installed it.
To Next Page
Loading...
