What to do if my Radio Shack 12-251 has no power?
If your Radio Shack Weather Radio isn't powering on, ensure it's properly connected to an AC power source. If the AC power is out, check that a backup battery is correctly installed.
How to fix no sound on Radio Shack 12-251?
If there is no sound coming from your Radio Shack Weather Radio, try adjusting the VOLUME or TONE settings.
What to do if no weather broadcast when I press WEATHER on my Radio Shack 12-251 Weather Radio?
If you're not getting a weather broadcast when you press the WEATHER button on your Radio Shack Weather Radio: - Ensure the telescoping antenna is fully extended. - Verify that the Weather Radio is set to the correct NOAA channel broadcasting in your area.
Why is my Radio Shack 12-251 not responding to NWS weather alert broadcasts?
If your Radio Shack Weather Radio isn't responding to NWS weather alerts, ensure you have programmed the correct FIPS codes into the radio's memory. Also, verify that the PROGRAM/OPERATE switch is set to OPERATE.
How to clear the C-OP (check operation) message on my Radio Shack Weather Radio?
The 'C-OP' message appears on your Radio Shack Weather Radio when it hasn't received a SAME alert signal (including test signals) for about 192 hours. To resolve this: - Ensure the FIPS codes stored in the memory are correct. - Make sure the telescoping antenna is fully extended.
What to do if my Radio Shack Weather Radio responds to alerts outside programmed FIPS codes?
If your Radio Shack Weather Radio is responding to weather alerts for areas not covered by the stored FIPS codes, ensure that the all-signals code (99) is not stored in the memory.
Warnings about fire/shock hazards, exposure to rain/moisture, and product enclosure.
Explains symbols for dangerous voltage and accompanying literature.
Details FCC rules, interference limits, and the device's compliance.
SAME operation, audible alerts, and selectable alert functions for customized notifications.
Ability to select NOAA weather broadcast frequencies for local information.
Display shows alert status: statement, watch, warning, or emergency.
Uses a 9-volt battery for backup power during AC power interruption.
Adjusts the volume of the siren for audibility.
Describes how the Weatheradio signals an alert, including siren and indicator lights.
Explains how the NWS divides the US into regions with 6-digit FIPS codes for weather alerts.
Details AC power use and the requirement for a 9-volt battery for backup.
Steps to connect the Weatheradio to a standard AC outlet.
Instructions on using the VOLUME control to turn the device on and off.
Steps to select and listen to NOAA weather broadcasts using the WEATHER button.
Instructions to adjust the volume of the alert tone using the TONE control.
Describes two ways the Weatheradio can respond to alerts: VOICE (alert + broadcast) or TONE (alert only).
General| Brand | Radio Shack |
|---|---|
| Model | 12-251 |
| Category | Weather Radio |
| Language | English |
To Next Page