Radio Shack 12-260 - Step Five RF Signal Strength Indicator; Step Six Alert Broadcast Response; Step Seven Alarm Enable and Snooze

Step Five
RF Signal Strength
The signal strength indicator ( j ) shows the level
of receiving signal. If the signal is lost and the
signal loss reminder is enabled, the radio emits a
short beep at 30 seconds, 1 minute, 1.5 minute,
and so on till 5 minute intervals. It then: sounds
every five minutes until you press any key, or
until a signal is received.
If you press any key to silence the reminder, the
reminder beeps will be terminated. If a signal is
detected for more than 10 minutes and then lost
again, the reminder beep will regenerate.
Step Six
You can set the Weatheradio® to respond to an
NWS (NOAA) alert broadcast in two ways:
ON OFF
ON OFF
SNOOZE
ALERT
ON - When ALERT is set to ON and an
alert broadcast is received, an alert sounds
for five minutes. To stop the alert and listen
to the broadcast, press WEATHERI
SNOOZE. Press WEATHER/SNOOZE
again to turn off the weather broadcast.
OFF - When ALERT is set to OFF and an
alert broadcast is received, an alert sounds
for 10 seconds. The radio then automatically
switches to the weather broadcast for five
minutes. Press WEATHER/SNOOZE to
switch from the alert tone to the broadcast
before the 10 seconds, or to stop the
broadcast before it automatically stops.
Step Seven
Enable/Disable the Alarm
1. Slide ALARM to ON or SNOOZE to enable
the alarm ... appears.
2. The alarm sounds at the preset alarm time,
becoming progressively louder the longer it
sounds.
3. To snooze, press WEATHER/SNOOZE. The
alarm stops for 10 minutes. After 10
minutes, the alarm sounds again until you
slide ALARM to OFF to turn it off.