Radio Shack 15-2526 - Using Your RF Modulator

4
To TV
If your TV is already connected to a VHF input source(cable,
antenna,etc.),disconnecttheVHFinputsourcefromyourTV,
andconnectitscabletothemodulator’sANT INterminal.
Then,usea75-ohmcoaxialcable(notsupplied)toconnect
themodulator’sTO TVterminaltoyourTV’s75-ohmVHF/UHF
terminal.
If your TV is not already connected to a VHF source,connect
a75-ohmcoaxialcabletothemodulator’sTO TVterminalto
yourTV’s75-ohmVHF/UHFterminal.IfyourTVhas300-ohm
VHFscrewterminals,usea75-ohm-to-300-ohmmatching
transformertocompletethisconnection.
Whenconnectionsarecomplete,plugthemodulatorintoa
standardACoutlet.
2 Use your Modulator
1. TurnonyourTVandturnittoChannel3or4(theone
notusedforregularbroadcastsinyourarea).
2. SettheCHANNEL 3/4
switchonthemodulator
tothesamechannelas
yourTV.
3. Turnontheconnected
videosource.The
modulator’sgreen
LEDlightswhenitis
receivingasignalfrom
anA/Vsource.
4. TowatchTV,turnoff
theconnectedvideo
source.IfyourTVdoes
TheLEDlightsredwhenyour
modulatorisconnectedtoanAC
outlet.Whenthemodulatorreceives
asignalfromanA/Vsource,thered
LEDturnsgreen.