Need help?Do you have a question about the Radio Shack RF Modulator and is the answer not in the manual?
Video and RF Specifications| video carrier output level | 63 dB µV |
|---|---|
| RF output channels | 3 or 4 |
| RF output impedance | 75 Ohms |
Input Impedance| video input impedance | 75 Ohms/1 kOhms |
|---|---|
| audio input impedance | 13 ± 3 kOhms |
Designed to convert audio/video signals into normal VHF TV signals for viewing on any TV set.
Device complies with Part 15 of FCC Rules, subject to conditions regarding interference.
Steps to resolve TV/radio interference caused by the RF Modulator, including repositioning and circuit changes.
Tampering with internal components voids warranty and FCC authorization; seek qualified service.
Lists audio/video cables, coaxial cables, and matching transformer needed for setup.
Reminder for CATV installers regarding proper grounding connection as per NEC article 820-40.
Connect audio/video cables from your video source to the RF Modulator's VIDEO IN and AUDIO IN jacks.
Connect coaxial cables to the RF Modulator's ANT IN and TO TV terminals, following specific guidelines.
Connect the input source's coaxial cable to ANT IN and use a separate cable for TO TV terminal.
Plug the RF Modulator's power cord into a standard AC outlet.
Turn on the TV and set it to channel 3 or 4; set the RF Modulator's switch to the same channel.
Use the MOD/ANT switch to select between ANT (VHF source) or MOD (audio/video source).
When setting MOD/ANT to MOD, adjust the OHMS 1K/75 setting for the best picture.
Lists output level, RF output channels, input/output impedance, and audio input impedance.
Provides 90-day warranty against defects, terms, conditions, and limitations of the warranty.
To Next Page
