5
PARTS REQUIRED
You need the following items, not supplied with your RF
Modulator, to connect it between a video input source
(video camera, satellite receiver, etc.) and your TV.
• Two audio/video (not stereo) shielded cables with
phono connectors
• Two 75-ohm coaxial cables with F-type connectors
• If your TV does not have a VHF 75-ohm F-connec-
tor, you will also need a 75-ohm-to-300-ohm match-
ing transformer
Your local Radio Shack sells a wide selection of each of
these items.
Note to CATV Installer:
This reminder is provided to call the CATV system install-
er’s attention to article 820-40 of the NEC that provides
guidelines for proper grounding and, in particular speci-
fies that the cable ground shall be connected to the build-
ing’s grounding system, as close as practical to the point
where the cable enters the house.
15-1283.fm Page 5 Thursday, July 15, 1999 2:19 PM
To Next Page
Loading...