8
• If your TV is not already connected to another
VHF source:
a.Connect the input source’s (antenna, cable TV,
VCR, etc.) 75-ohm cable to the RF Modulator’s
ANT IN
terminal.
b.Connect a 75-ohm coaxial cable between the
TO TV
terminal on the RF Modulator and the
75-ohm VHF input terminal on your TV.
N
ote:
If your TV has only 300-ohm VHF screw ter-
minals, use a 75-ohm-to-300-ohm matching trans-
former to complete the connection.
CATV
Ant In To TV
75 Ohm 300 Ohms
VHF
RF Modulator TV
15-1283.fm Page 8 Thursday, July 15, 1999 2:19 PM
To Next Page
Loading...