Radio Shack 3-in-One Pocket Remote User Manual

Need help? Call 1-888-533-7135
7
Need help? Call 1-888-533-7135
7
No. 16-421 or 16-422), you must program the
TV code for the TV functions
and
the VCR
code for the VCR functions.
2. Press the device key for the type of remote you
are replacing (
TV
,
VCR
, or
CBL
). The red light
blinks.
3. Hold down
P
until the red light blinks twice, then
enter the 4-digit code using the keys shown
here:
For example, to replace a TV’s remote control
(manufacturer’s code 1433), press
TV
, hold
down
P
until the red light blinks twice, then
press
CH
,
CH
,
VOL
, and
VOL
.
When the red light blinks twice, the remote con-
trol has accepted the code.
Note:
If the code you entered is invalid, the red
light does not blink.
4. Point the remote control at your device and
press
PWR
Your device should turn off (or on, if
it was off).
If the remote does not operate your device, try
the other codes listed in “Manufacturers’ Codes”
on Page 12 for your brand of TV, VCR, cable
converter, or other device.
5. Repeat Steps 2–4 for additional devices.
Press To Enter
This Number
CH
1
VOL
2
VOL
3
CH
4
15-1930.fm Page 7 Monday, July 19, 1999 1:09 PM

Radio Shack 3-in-One Pocket Remote Specifications

General

Brand	Radio Shack
Model	3-in-One Pocket Remote
Category	Universal Remote
Language	English