The Integrated Answering Device
22
2. Press
SELECT/VOLUME/ or SELECT/VOLUME/
until the desired ring time appears.
3. Press
set to select the new ring time. You hear
a confirmation tone, then the announcement
“Ring time” and the new ring time is
announced. After a few seconds, the system
announces “To set record time, press menu
again”.
Selecting the message Record Time
You have three record time options. The options “1
minute” or “
4 minutes” set the duration for recording
the incoming messages. “
Announce only” answers
the call with the preset greeting or your personal
greeting but prevents the caller from leaving a
message.
1. Press
clock/menu four times in standby mode.
You hear “Record time” and the current
recording time ([ ] 1 minute, [ ] 4 minutes, [ ]
Announce only, No recording), and it is
displayed on the base. Then you hear the
guidance for setting the record time.
2. Press
SELECT/VOLUME/ or SELECT/VOLUME/
until the desired time appears.
3. Press
set to select the new recording time. You
hear a confirmation tone, then the
announcement “Record time” and new
recording time is announced. After a few
seconds, the system announces “To set
message alert, press menu again”.
Announce only feature
The announce only feature plays a prerecorded
outgoing message “Hello, no one is available to
take your call. Please call again.”, and it will not
allow the caller to leave a message. To set
“Announce only”, follow the steps above. The
43-3823.FM Page 22 Thursday, March 27, 2003 10:22 AM
To Next Page
Loading...
