Radio Shack 43-3905 - Dial Mode Setup

7
Dial Mode
SlideTONE/PULSEtothesettingforthetypeofdialingservice
youhave.Ifyouarenotsurewhichtypeyouhave,dothis
simpletest.
1. SlideTONE/PULSEtoTONE.Liftthehandsetandlistenfor
adialtone.
2. Pressanynumberexcept0.(Ifyoursetuprequiresthatyou
dialanaccesscode,usually 9,beforeyoudialanoutside
number,donotpresstheaccesscodenumber.)
• Ifthedialtonestops,youhavetouchtoneservice.Keep
theswitchonTONE.
• Ifthedialtonecontinues,youhavepulseservice.Set
theswitchtoPULSE.
Using Special Tone Services
Somecomputerservicesrequiretonesignalsforcommunications.
Ifyouhavepulseservice,youcanstillsimulatetonesignalsby
followingthesesteps.
1. Connecttothespecialserviceusingpulsedialing.
2. Whenthespecialserviceanswers,press
*
totemporarily
switchtotonedialing.
3. Whenyoucompletethecall,hanguptochangethesetting
backtoPULSE.
Master/Secondary Setting
Formodernphonessystems,slideM/Sto M.
n Notes:
• IfyouhaveotherphoneswithaMaster/Secondaryswitch,setthem
to S.Setonesystemtoanswerandsettheotherstooff.
• IfM is not set on at least one phone, incoming calls might be
disconnected.