Radio Shack Chronosette-276 - Chronosette-276 Technical Specifications; Radio Frequency Specifications; Cassette Player Tape Specs; General and AM Band Specifications

Chronosette-276 (120-1584) Specifications Faxback Doc. # 3772
RADIO
Frequency Range.............................................FM: 88-108 MHz
AM: 530-1710 MHz
CASSETTE PLAYER
Tape Speed.......................................................1 7/8 ips
Erasing System..............................................Magnetic Erase
Recording System...................................................AC Bias
GENERAL
Power Output.........................................................700mW
Speaker..................................................3 1/2 Inch, 8 Ohm
Permanent Dynamic Type
Dimensions...........................13 5/8 x 4 1/3 x 5 11/16 Inches (HWD)
Weight...............................................................4 lbs
Power Requirements.................................AC: 120 volts 60Hz, 10W
220/240 volts 50 Hz for European/Australian Models
Room temperature...............................77 degrees F (25 degrees C)
AM BAND
Speaker impedance:..................................................8 ohms
Output readings are taken across a non-reactive load.
Output reference level is 50mW total power.
The generator output shall terminate in an IRE loop with the loop pointing
toward rear of receiver.
Modulation:...................................................1000 Hz, 30%
UNIT NOMINAL LIMIT
Frequency Coverage kHz 510-1750 520-172
IF kHz 455 +/-3
Antenna Sensitivity
for S/N 20 dB at 600 kHz microV/M 500 900
at 1000 kHz microV/M 500 900