10
PREPARATION
INSTALLING A BATTERY
You need one 9V battery (not supplied) to provide backup pow-
er for the CID-932’s memory in the event of a power failure. For
the best performance, we recommend an alkaline battery, avail-
able at your local RadioShack store.
Cautions:
• Use only a fresh battery of the required size and recom-
mended type.
• Always remove old or weak batteries. They can leak chem-
icals that can damage electronic circuits.
Follow these steps to install the battery.
Note:
The screw is packed separately. Insert the screw into the
battery compartment cover when you first install the battery.
1. Use a small Phillips screwdriver to remove the screw from
the battery compartment cover.
2. Lift the cover in the direction of the arrow.
3. Place a fresh battery in the compartment, as indicated by
the polarity symbols (
+
and
–
) marked inside.
4. Replace the battery compartment cover and tighten the
screw.
9 VOLT BATTER Y9 VOLT BATTER Y
43-932.fm Page 10 Wednesday, January 12, 2000 9:56 AM
To Next Page
Loading...