direct access, preset, or scan tuning methods.
Manual Tuning
To manually tune to a frequency, repeatedly press MANUAL/AUTO <DOWN or UP>
until the display shows the frequency desired.
Search Tuning
To let the receiver find a station, press and hold <DOWN or UP> for more
than 2 seconds. The tuner quickly scans all frequencies. When you
release the button, the receiver automatically tunes to the next strong
station.
Direct Access Tuning
To tune directly to a station's frequency, press ENTER. ENTRY flashes for
about 10 seconds. While it is flashing, press the number buttons to
select the desired station's frequency. Then press ENTER again.
NOTES: Your receiver automatically rounds the entered frequency to the
nearest valid frequency. For example, if you try to enter a
frequency of 1453 in AM, your receiver accepts it as 1450.
If you make a mistake in entering a frequency, ERROR flashes on
the display. Enter the frequency again.
Preset Tuning
To tune directly to a station that is entered into memory, simply press
the desired preset number (0-9).
NOTE: You must first store the desired stations into memory. (See
"Storing Station Frequencies.")
Scan Tuning
To scan the preset memory locations, press SCAN. The receiver stops at
each station for about 5 seconds. To end scanning, press SCAN again, or
press a preset station memory button.
NOTE: If no frequency is stored in a memory channel or no signal is
received at a memory channel, the receiver stops at the memory
channel for 1 second and then moves to the next memory channel.
STORING STATION FREQUENCIES
For easy selection, you can store up to 30 of your favorite stations'
frequencies in memory (10 frequencies in each band; FM, AM, and SW). Once
you store a station's frequency using a memory button, you can press this
button to select the stored station.
To Next Page
Loading...
Need help?
General
