CAUTION: If you disconnect power from the receiver for about 1 hour, all
information stored in memory will be lost. We recommend you
keep the batteries installed when you use an AC or DC adapter to
protect the memory from a power loss.
Follow these steps to store a frequency in memory.
1. Follow Steps 1 through 4 in "Basic Operation."
NOTE: Use manual, search, or direct access tuning to tune to the
station's frequency you want to store.
2. Press STORE. MEMORY flashes.
3. While MEMORY flashes, press a number button to select the memory
location.
NOTE: If you do not press a number within about 10 seconds, MEMORY stops
flashing and you must repeat steps 2 and 3.
USING THE ANTENNA
Use the following guidelines to adjust your receiver's antenna.
BAND Wavelength Antenna adjustments
FM Fully extend and rotate the telescoping antenna.
AM Rotate the receiver for best reception, (AM uses
an internal antenna.)
SW 13-41 meters Fully extend the telescoping antenna vertically.
SW 49-120 meters Fully extend the telescoping antenna and/or
rotate the receiver for best reception. (Both
internal and external telescoping antennas pick
up signals.)
NOTE: For better AM and SW reception, you can connect an external
antenna, such as Cat. No. 278-1374, to the telescoping antenna.
(ALL-02/27/95)
To Next Page
Loading...
Need help?
General
