10
Replace Damaged Propellers
The left and right propellers of the drone
are dierent, and marked A/B on the
propeller and axles). You must use the
correct propeller in the correct location,
otherwise the drone will fail to take o.
To replace a damaged propeller, remove
the old one and press the new one onto
the propeller axle. If you cannot remove
the old propeller by hand, carefully use
pliers.
WARNING:
• To avoid injury and damage, check the propellers for nicks and breaks and make
sure they are securely attached before and after each ight. Replace any damaged
propellers.
• Use only the supplied propellers. Do not alter, modify, or customize the propellers.
Troubleshooting
Drone does not respond
• Make sure the drone and remote control are switched on and paired.
• Drone battery maybe low. Fully charge the battery. See “Charge the Drone
Battery.“
• Remote control batteries maybe low. Replace the batteries.
• Make sure the drone is within the control range (120 ft./36.5 m) and in line of
sight.
Drone difficult to control
• The throttle control is very sensitive. Use small, ne movements to control.
• Practice in Ez (Easy) mode.
• Propellers maybe deformed or damaged. Adjust propellers by hand. If you
cannot adjust them, replace with the spare propellers.
Drone swerves or moves erratically before taking off
• The gyroscope inside your drone needs calibrating: Do the following:
1. With your drone and remote control switched on and paired ( Ex or Ez),
place the drone on level ground.
2. Move the throttle all the way down and the steering
forward at the same time. Hold this position for
a few seconds until the drone LEDs start to blink.
When the drone LEDs light steadily, release the
B
A
A
B
Back Blades (black)
Front Blades (red)
To Next Page
Loading...
