4
Charge the Drone Battery
Make sure you use the supplied battery and battery charging cable, or one
of the same type: 3.7 V, 390mAH lithium polymer.
1. Use the USB charging cable to connect the battery to a USB power
source. The LED on the USB connector lights red during charging, and
turns o when charging is complete.
A full charge takes about 60 minutes. A fully charged battery provides up
to 5 minutes of ight and camera time.
LED
2. After charging, unplug the USB charging cable. Do not attempt to
overcharge the battery.
3. To install the battery,
match and plug the
two ends of the white
battery connectors.
They only t one way,
so do not use force.
Neatly slot the battery
and cables into the
drone's slot battery
compartment.
CAUTION: After playing, let
the built-in battery cool at least 20 minutes before charging again.
Lithium Battery Notes
• Do not charge longer than recommended. Unplug the charging cable when
the drone is charged.
• Do not puncture or crush. Do not disassemble.
• Do not dispose of lithium batteries in the trash.
• If the electrolyte in the cells should get on your skin, thoroughly wash with
soap and water. If in the eyes, rinse thoroughly with cool water. Immediately
seek medical attention.
• Do not attempt to charge or operate damaged toys.
Recycle Rechargeable Batteries
Recycle used rechargeable batteries at one of the many collection
sites in the U.S. and Canada. To nd the site nearest you, visit www.
call2recycle.org or call 1-800-822-8837.
To Next Page
Loading...
