5
Install Batteries in the Remote Control
1. Make sure the remote control is turned o.
2. Use a screwdriver to open the twin battery compartments. Then insert
four AAA batteries (not included), matching the polarities (+ and –)
marked inside. Replace the cover.
Note: If the remote control’s LED ashes during use, the batteries are low
and should be replaced.
Battery Notes
• Dispose of old batteries promptly and properly. Do not burn or bury them. Use
only fresh batteries of the required size and recommended type.
• Do not mix old and new batteries, dierent types of batteries (standard,
alkaline, or rechargeable), or rechargeable batteries of dierent capacities.
• Remove batteries during longer storage periods. Batteries can leak chemicals
that can damage electronic parts.
About Expert/ Easy Fly Modes (Ex/Ez)
This drone is designed with 2 ight modes:
Ex (Expert) for advanced pilots to y at a higher speed and
perform stunts.
Ez (Easy) for beginners and new drone owners. This
operates at a slower speed to help you focus on basic
navigation and develop a feel of the throttle's sensitivity. By default, in Ez
mode, the stunt and speed options are disabled to prevent them from being
accidentally activated.
• When pairing and ying for the rst time, we recommend you use Ez for
test ights and honing your takeo, steering and landing skills.
Pairing
1. Turn on the drone. The drone's LEDs ash.
2. Place the drone on level ground.
To Next Page
Loading...
