4-IN-ONE REMOTE POWERED BY KAMELEON
12 Setting the Tilt Switch
3. Press DVD then VCR. The VCR key is now
ready to be programmed as your second
DVD player. (see “Programming A
Device” on page 7).
NOTE: Only one device can be assigned
to an unused device key at a time.
4. If desired, repeat steps 1 to 3 to reassign
another device.
SETTING THE TILT SWITCH
The RadioShack 4-in-One Remote contains a
Tilt Switch that activates the display when the
unit is moved. If desired, you can disable it so
only pressing a key will turn on the display.
NOTE: Disabling the Tilt Switch can help
conserve battery life.
DISABLING THE TILT SWITCH
1. Press and hold P until the IR segment
flashes twice.
2. Using the number keys, enter 9 8 5. The
IR segment will flash four times,
confirming the Tilt Switch is disabled.
ENABLING THE TILT SWITCH
1. Press and hold P until the IR segment
flashes twice.
2. Using the number keys, enter 9 8 5. The
IR segment will flash twice, confirming
the Tilt Switch is enabled.
USING MACROS
The RadioShack 4-in-One Remote allows you
to assign a single key to perform a repetitive,
time-consuming operation.
A macro can be used to control a home
theater operation, to set a favorite channel, or
for other multiple functions you would like to
control with one key press. Moreover, the key
you assign to activate your macro can hold up
to 15 key presses total.
Macros are not mode-specific. The macro will
run when you press the activation key, no
matter what mode you are in.
NOTE: Programming a new macro over the
existing one will erase the original macro.
PROGRAMMING A MACRO (EXAMPLE)
Watching a movie can involve a lot of
complicated turning on of devices and
adjusting control. Or, you can set up
RadioShack 4-in-One Remote to do all this
with one key press.
1. Press and hold P until the IR segment
blinks twice, then release.
2. Press 9 9 5. The IR segment will blink
twice.
3. Press Power (or whatever key you want
to assign the macro to).
NOTE: You cannot use P, FAV SCAN or the
mode keys (TV, VCR, DVD, CBL/SAT) as the
macro key.
4. Enter the series of commands you want
the macro to execute (up to 15
commands).
NOTE: If there are more than 15 key
presses in the sequence, the IR segment
will display a long flash denoting an
error. The display will return to the last-
selected device menu screen. To program
the macro, start again with step 3.
5. Press and hold P until the IR segment
blinks twice, then release.
Now, when you press the Power key, the
remote will send the series of commands you
have entered. For example, you could
program the Power key to turn on both your
TV and cable box and select a particular
channel.
RS 4in1 Kam User Manual.fm Page 12 Friday, March 4, 2005 9:09 AM
To Next Page
Loading...
