Radio Shack MD-1210 - Layer and Combined Modes; Layer Mode; Split and Layer Together

12
Operation
To select a different low-end tone, enter
the three-digit number for the new low-
end tone while the SPLIT indicator ap-
pears. To select a different high-end
tone, press
SPLIT
to turn off its indicator,
then enter the three-digit number for the
new high-end tone. Then press
SPLIT
again so the SPLIT indicator appears.
To cancel SPLIT play, repeatedly press
SPLIT
until its indicator disappears.
Notes:
• If SPLIT is on when you turn off the
keyboard, SPLIT will still be on the
next time you turn on the keyboard.
• When you turn on SPLIT, the last
selected settings appear.
USING LAYER
The keyboard lets you play two different
preset tones at the same time, creating
a “layered effect” when you press one
key. The first tone you select when us-
ing LAYER is called the
base tone
and
the second tone is called the
layer tone
.
1. Press
TONE
.
2. Enter the three-digit number for the
base tone then press
LAYER
. The
LAYER
indicator appears.
3. Enter the three-digit number for the
layer tone.
4. Play the keyboard to hear the
selected layered tones.
To select a different layer tone, enter the
three-digit number for the new layer tone
while the LAYER indicator appears. To
select a different base tone, press
LAY-
ER
to turn off its indicator, then enter the
three-digit number for the new base
tone. Then press
LAYER
again so the
LAYER indicator appears.
To cancel LAYER, repeatedly press
LAYER
until its indicator disappears.
Notes:
• If LAYER is on when you turn off the
keyboard, LAYER will still be on the
next time you turn on the keyboard.
• When you turn on LAYER, the previ-
ous tone settings appear.
USING SPLIT AND LAYER
TOGETHER
You can combine the SPLIT and LAYER
features, so you can play one layered
combination of tones on the low-end
keys and another on the high-end keys.
1. If the SPLIT or LAYER indicator is
on, press
SPLIT
or
LAYER
to turn it
off.
2. Enter the number for the high-end
base tone on the keypad.
3. Repeatedly press
SPLIT
until the
SPLIT indicator appears.
4. Enter the number for the low-end
base tone.
5. Repeatedly press
SPLIT
until the
SPLIT indicator disappears.
6. Repeatedly press
LAYER
until the
LAYER indicator appears.
7. Enter the number of the layered
tone for the high-end keys.
8. Press
SPLIT
. The SPLIT indicator
appears.